With Viking, you can have professional-quality refrigeration systems in the comfort of your own house. It makes good sense that you would not wish to trust your financial investment to just any type of device repair work firm. That’s why you need to call the Viking refrigerator repair service experts.
We offer superior Viking refrigerator fixing service 7 days a week. Our professionals get on call everywhere near your area. When you require premium support for your premium refrigerator, call us.
The control device of your Viking fridge monitors the essential components of the device. If a mistake is discovered, the electronic display provides a mistake code to assist situate and fix the issue.
The first step to fixing any type of issue is to confirm the mistake is legitimate. To confirm an error code, you will certainly need to reboot the refrigerator.
To reboot your refrigerator:
Disconnect the refrigerator from the wall surface or shut off power to the outlet at the breaker.
Wait five mins.
Return power to the refrigerator.
If the error code returns, it is a legitimate mistake. Describe the adhering to graph for additional fixing aid.
Mistake Code Detection
The microprocessor in the control continually checks vital refrigeration system components for proper procedure. If component criteria surpass typical operating specifications, an audible alarm system will certainly appear six (6) times every minute and the display screen will immediately flash the respective error code. If numerous errors are kept in mind with the system, the mistake codes will be displayed sequentially.
Caution Alarm system
The Tru Protect ™ system will inform you if the device is not functioning properly. It gives both visual as well as audible alerts if the temperature level rises above or falls listed below the set temperature, if there is a power failing, or if the door is left ajar.
- Door Ajar: If the door is left open for greater than five (5) minutes, a distinct alarm will seem 3 (3) times every 30 seconds and also the LED light will certainly blink eco-friendly. This will quit as soon as the door is closed.
- High and Low Temperature Level: If the unit gets to a temperature either above or below the set point temperature for greater than one (1) hour, a distinct alarm system will certainly sound six (6) times every minute as well as the LED will certainly blink red. This will proceed up until the alarm is reset. The alarm might occur when changing set-points in excess of 10 degrees F and/or high usage which is regular.
- Power Failing: If the device experiences a power failure, the LED will blink brownish-yellow. This will continue until the alarm is reset. With a power failure, no distinct signal is listened to. The alarm may occur upon preliminary installment which is typical given that the system was run at the manufacturing facility to validate top quality.
Resetting the Alarms
Close door to reset Door Ajar alarm system. Press the “ON/OFF” switch for around one (1) 2nd to reset all other audible and display alarms.
KEEP IN MIND: Although pressing the “ON/OFF” switch will reset the alarms, the alarm system will certainly resume if the “alarm system condition” still exists.
Service Diagnostics Setting
Solution Diagnostics Setting enables you to identify the firmware and also software application versions, examination condition of “design details” system parts and also sensing units, and change state of parts where appropriate (i.e.– compressor on/off, and so on.).
ERROR CODE | CAUSE | SOLUTION |
E1 | A compressor fault has been detected | The issue may be caused by disconnected compressor wires, a faulty compressor, control, or the compressor PTC starter. It may also be the result of a compressor overload. |